Skeleton of revolver. Handle, hammer and cylinder missing, barrel broken at end. Accompanied by papers, yellow with CRW writing: “Old Navy Cap and Ball Revolver 36 Calibre a 6 shooter Whitney Whitneyville, Conn. 1850 - 1860. Found by Larry, son of Archie Daniels in remians of a cabin in Kanan…
Skeleton of revolver. Handle, hammer and cylinder missing, barrel broken at end. Accompanied by papers, yellow with CRW writing: “Old Navy Cap and Ball Revolver 36 Calibre a 6 shooter Whitney Whitneyville, Conn. 1850 - 1860. Found by Larry, son of Archie Daniels in remians of a cabin in Kananaskis Valley above lakes. Found in 1975.” and a white paper with “Dr. Pactos; Thankyou for your trouble. I think it is a Stan Arms Co. .44 made in new York around the 1850s would be interested in how close I came. Again Thanks John M” along with “Whitney, .36 Calibre Navy Cap & Ball 1850-60.”
A silver shoehorn with a curved blade that narrows into a handle. There is an embossed floral pattern on the inside of the handle. The shoehorn in marked with three hallmarks and “Sterling B 350”.
A silver shoehorn with a curved blade that narrows into a handle. There is an embossed floral pattern on the inside of the handle. The shoehorn in marked with three hallmarks and “Sterling B 350”.
A sword with a single edged steel blade set a into wooden hilt which is wrapped with thin strips of leather. There are three metal rings at the joint of the handle and blade.
A sword with a single edged steel blade set a into wooden hilt which is wrapped with thin strips of leather. There are three metal rings at the joint of the handle and blade.
A strong, single edged hunting knife with a cross piece. The hilt of the knife is made of brass, and covered with leather. The blade is marked “Collins and Co. Hartford Serofino #17 (Galidad)”. (b) Sheath made of leather with steel tip and steel detailing. Leather is embossed with crown and leav…
A strong, single edged hunting knife with a cross piece. The hilt of the knife is made of brass, and covered with leather. The blade is marked “Collins and Co. Hartford Serofino #17 (Galidad)”. (b) Sheath made of leather with steel tip and steel detailing. Leather is embossed with crown and leaves. “LEGITIMUS” is stamped under the crown and the number ”10” is stamped on a cross piece above.
A heavy cast iron teakettle that has a rounded body and a long, curved spout. The kettle has a domed lid with a small knob handle. The kettle has a high, arched handle that attaches to the kettle’s shoulder above the spout and also on the opposite side. The bottom of the kettle is marked with “F…
A heavy cast iron teakettle that has a rounded body and a long, curved spout. The kettle has a domed lid with a small knob handle. The kettle has a high, arched handle that attaches to the kettle’s shoulder above the spout and also on the opposite side. The bottom of the kettle is marked with “Falkirk No.0 6 pints”.
A straight-sided copper-plated bucket with a flat box-type lid. The lid has a wide strap of metal at the centre to hold a heavy round ring handle. There is a long, heavy, round carrying handle that hangs from loops attached to the sides of the bucket. The top of the lid has a design of small lin…
A straight-sided copper-plated bucket with a flat box-type lid. The lid has a wide strap of metal at the centre to hold a heavy round ring handle. There is a long, heavy, round carrying handle that hangs from loops attached to the sides of the bucket. The top of the lid has a design of small lines in a spiral pattern.
A brass skimmer with a long flat handle with a cut-out trefoil design at the end. The handle opens into diamond shape and triangle shape just above where the bowl of the skimmer attaches to the handle with two copper rivets. The skimmer bowl is slightly cupped, large and wide, and is completely p…
A brass skimmer with a long flat handle with a cut-out trefoil design at the end. The handle opens into diamond shape and triangle shape just above where the bowl of the skimmer attaches to the handle with two copper rivets. The skimmer bowl is slightly cupped, large and wide, and is completely pierced with round holes following the shape of the skimmer.
A brass toasting fork a with long handle that is decorated with indentations alternating on opposite sides along its length. The handle is flat and wide with a filigree design that is repeated at the toasting end just above two sharp flat tines.
A brass toasting fork a with long handle that is decorated with indentations alternating on opposite sides along its length. The handle is flat and wide with a filigree design that is repeated at the toasting end just above two sharp flat tines.
A round wooden butter mold that is a circular press carved with a handle which passes through a hole in the top of the mold. The press has a thistle and leaf design carved into it.
A round wooden butter mold that is a circular press carved with a handle which passes through a hole in the top of the mold. The press has a thistle and leaf design carved into it.
An oval silver-plated copper dish with a flared lip. The dish stands on a short pedestal with a square base. The dish has a tall arched handle that is hinged and attached on each side. The basket is decorated with ornate floral trim along the edge of the dish and along the top of the handle.
An oval silver-plated copper dish with a flared lip. The dish stands on a short pedestal with a square base. The dish has a tall arched handle that is hinged and attached on each side. The basket is decorated with ornate floral trim along the edge of the dish and along the top of the handle.
A silver-plated water pitcher, with shoulders that narrow in to the neck, on a round base. The mouth of the pitcher, decorated with shaped silver trim, is elongated at one side to form a pouring lip. The handle of the pitcher has a flat section at the top, and then curves in to where it is joined…
A silver-plated water pitcher, with shoulders that narrow in to the neck, on a round base. The mouth of the pitcher, decorated with shaped silver trim, is elongated at one side to form a pouring lip. The handle of the pitcher has a flat section at the top, and then curves in to where it is joined to the pitcher just below the shoulder. “M F D & PLATED BY REED & BARTON 5400” is stamped on the base.
A tall, tower shaped, silver plated sugar shaker resting on an octagonal base. The shaker has a tall domed lid that is pierced with a pattern of comma-shaped holes and round holes. The lid is surmounted by a spire of four stacked balls.
A tall, tower shaped, silver plated sugar shaker resting on an octagonal base. The shaker has a tall domed lid that is pierced with a pattern of comma-shaped holes and round holes. The lid is surmounted by a spire of four stacked balls.
A silver plated round plate with heavy trim along the edge. The rim is monogrammed with “JMR” in intertwined script. The bottom of the plate is marked with “G M Co” and “EP 0610 141n”.
A silver plated round plate with heavy trim along the edge. The rim is monogrammed with “JMR” in intertwined script. The bottom of the plate is marked with “G M Co” and “EP 0610 141n”.
An ornate glass with a coloured bowl on a tall clear stem and round base. The bowl is decorated with gilt bands, dots and glass 'jewels' in relief accented with a gilt design. The base is clear glass with coloured glass 'jewels' in diamond shaped gilt settings.
An ornate glass with a coloured bowl on a tall clear stem and round base. The bowl is decorated with gilt bands, dots and glass 'jewels' in relief accented with a gilt design. The base is clear glass with coloured glass 'jewels' in diamond shaped gilt settings.
A tableware set consisting of a gravy boat and saucer (a,b), a platter (c), a butter dish with cover (d), and six dessert plates (e-j). Each piece has a white background with gold checked border at the rim with a gold filigree decoration around the border. Each piece, except the butter dish, conta…
11.0 (a); 16.0 (d) x 26.0 (a); 25.0 (b); 50.0 (c); cm
Description
A tableware set consisting of a gravy boat and saucer (a,b), a platter (c), a butter dish with cover (d), and six dessert plates (e-j). Each piece has a white background with gold checked border at the rim with a gold filigree decoration around the border. Each piece, except the butter dish, contains a red crown symbol at the border with a gold filigree design hanging beneath it. The butter dish is round, with the base forming a pedestal, and has a high domed lid. Each of the dessert plates have a picture of two cherubs at the centre.
A set of twenty-four dinner plates. Each plate is white with a gold checked border around a slightly shaped edge with a red crown at the top. There is a gold medallion in centre of each plate with a thin gold line around the bottom of the lip of the plate. Each plate is marked on the bottom with…
A set of twenty-four dinner plates. Each plate is white with a gold checked border around a slightly shaped edge with a red crown at the top. There is a gold medallion in centre of each plate with a thin gold line around the bottom of the lip of the plate. Each plate is marked on the bottom with a crown and “A II”.
A flatiron (a) that is resting on a trivet (b).a) The heavy cast iron flatiron is oval with pointed ends. The iron has a semi-circular round wooden handle which detaches from base of iron by pulling a wooden knob at the centre, under the handle, to release a spring (while the heating iron on a hot…
12.5 (a); 2.8 (b) x 9.9 (a); 10.6 (b) x 17.4 (a); 14.9 (b) cm
Description
A flatiron (a) that is resting on a trivet (b).a) The heavy cast iron flatiron is oval with pointed ends. The iron has a semi-circular round wooden handle which detaches from base of iron by pulling a wooden knob at the centre, under the handle, to release a spring (while the heating iron on a hot stove. b) The cast iron trivet is painted black. The trivet is triangular with a cut-out bars and hole design, and there is a short lip along the sides. The bottom of the trivet is marked “J.A.S. Smart Mrg. Co. Li-it-d Canada”.